loading
reading
writing
saving
searching
29 Crown Amplifier Chipboards - $200 (Roseville)
QR Code Link to This Post
Crown Pip2 IQpip-usp3 New - 4
Crown Audio 4-VCAP - 2-Gang Wall Control Panel for VCA-MC New - 1
Crown Audio RPA P.I.P Amplifier Programmable Input Processor New - 1
Box with 23 random used boards and chips
PIP-USP3 is a DSP-based PIP module that integrates into a 100-Mb Ethernet network via TCP/IQ protocol. An extremely versatile speaker-processing unit that mounts right in your Crown amplifier, this compact module greatly reduces the costs of typical audio systems while eliminating the rack space needed for signal processing. Offers up to thirty-two filters per channel as well as load supervision that continuously monitors the load impedance using the signal source as the test signal. Also includes compressors, limiters, error reporting, ten internal presets, up to 2 seconds of delay per channel, and noise and sine-wave generators. Also includes line voltage monitoring when installed in Crown CTs series amplifiers. Requires FREE IQwic Software and a computer for initial setup.
Features
100Mb Ethernet single-plug solution for TCP/IQ control and monitoring
Listen Bus amplifier output monitor
24 bit conversion with 32 bit, floating point DSP processing
64 assignable filters with 9 different filter types including all-pass filters
Over 2 seconds of delay available per channel
Input compressors and output limiters for each channel
Dual, uncorrelated noise generators for noise masking
Sine-wave generator
Load supervision
Full error reporting
Firmware upgrades via the network
10 user selectable presets
Amp amplifier speaker sound radio stereo